Ouellet ODL Bedienungsanleitung PDF herunterladen

180, 3

Avenue, L’Islet (Québec) G0R 2C0 CANADA

Phone. : (418) 247-3947, 1-800-463-7043,

Fax : (418) 247-7801

www.ouellet.com

INSTALLATION INSTRUCTIONS

‘‘ODL Series’’

FURNITURE AND DRAPES

- Formaximumsatisfactionanairowof3in.(76.2mm)

clearance is recommended.

- Also allow 1 in. (25.4 mm) clearance on top and bottom

of drapes when drapes cover wall.

INSTALLATION INSTRUCTIONS

1- Cut a hole in the box along the hash lines. Remove wire

holder (or knock-out) of the appropriate junction box.

2- Locate the locking device at the bottom center of the heater.

Withdraw the front cover by rotating counter clockwise the

locking device with help of a tool through air inlet.

3- Make connection according to local and national codes and

replace wire holder. (Do not forget ground wire.)

4- Install the relay or thermostat by removing the front cover and

the junction box cover.

5- Check wire connection at the other junction box.

6- Fasten the baseboard to the wall using wood screws,

tighten then release 1/2 turn.

7- Replace all covers before energizing.

INTERCONNECTION

- The connection boxes and wiring channel are approved for

interconnection of baseboard heaters and components which

are on the same heating branch circuit.

- The heater junction box minimum volume without options

is 46 in³ (760 cm³).

OPTIONS

All heating equipment and options must be installed

in accordance with local and national codes.

Built-in thermostat:

CAUTION: The thermostat should not be considered as an

infallible system where maintaining a temperature is considered

critical. Examples: Hazardous material storage, computer room,

etc. In these particular cases, it is imperative to add a monitoring

system to avoid the consequences of a failure of the thermostat.

- Refer to wiring diagram for connections.

- Refer to instructions supplied with the option for mounting.

Built-in relay:

- Refer to the diagram included with the relay option

for connections.

- Refer to instructions supplied with the option for mounting.

THE INSTALLATION MUST BE EXECUTED

BY A QUALIFIED TECHNICIAN

RISK OF ELECTROCUTION

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic precautions

shouldalwaysbetakentoreducetheriskofre,

electric shock, and injury, including the following:

Read all instructions before using this heater.

- A heater has hot and arcing or sparking parts inside.

 Donotuseitinareaswheregasoline,paint,orammable

liquids are used or stored.

- This heater is hot when in use. To avoid burns, do not let

bare skin touch hot surfaces. Keep combustible materials,

like furniture, pillows, bedding, papers, clothes, and curtains

away from heater.

-Topreventapossiblere,donotblockairintakesorexhaust

in any way whatsoever.

- Do not insert or allow foreign objects to enter any ventilation

 orexhaustopeningasthismaycauseanelectricshockorre,

or damage the heater.

- Do not install heater against combustible low-density

 celluloseberboardsurfaces.

- Do not use outdoors.

- CAUTION - High Temperature; Keep electrical cords, drapes,

and other furnishings away from heater.

- Use only with copper branch circuit conductors.

- For bathroom use, the heater must be installed so that

switches and other controls cannot be touched by anyone

in the bath or shower.

- Do not install this heating appliance beneath a wall outlet.

- To avoid possible electrical shock, disconnect all power

at the main panel prior to wiring, cleaning, or servicing.

- KEEP THESE INSTRUCTIONS.

INS343-201205-00

MAINTENANCE

- Once a year or at the need, remove the front cover and use

a vacuum cleaner to remove the dust accumulation inside

the heater.

- Cleaning should be done while the heater is disconnected

from the main service panel. Wait until the housing

and heating element cool before performing maintenance.

Remove the front cover.

CAUTION: Fins on the element are sharp - Do not touch.

Replace all covers before energizing.

- Anyotherservicingshouldbeperformedbyaqualied

technician.

WARRANTY

The manufacturer warrants the electric heating element of

this product for life. The other component parts are warranted

against defects in material and workmanship for a one year

period following the date of purchase, under normal use and

maintenance, provided that there is a proof of purchase to

conrmthisdate.Theobligationofthemanufacturer,under

the terms of this warranty, is limited to replacing the unit

(baseboard heater only) and excludes all other costs related

to the installation or replacement of the unit or spare parts.

WIRING DIAGRAM

High-Limit

Heating

Element

Heating

Element

Thermostat

ATTENTION

DRAPES

76.2 mm

3’’

25.4 mm minimum

1’’ minimum

12.7 mm

1/2"

122.7 mm

Unlock Lock

Inhaltsverzeichnis

Seite 1 - KEEP THESE INSTRUCTIONS

180, 3rd Avenue, L’Islet (Québec) G0R 2C0 CANADAPhone. : (418) 247-3947, 1-800-463-7043, Fax : (418) 247-7801www.ouellet.comINSTALLATION INSTRUCTIONS

Weitere Dokumente für Wasserkocher Ouellet ODL

Um das Dokument anzuzeigen Ouellet ODL Bedienungsanleitung

Ouellet ODL Bedienungsanleitung (1 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

Ouellet ODL Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Wasserkocher Ouellet ODL herunter. Ouellet ODL User Manual Benutzerhandbuch

Inhaltsverzeichnis

Weitere Dokumente für Wasserkocher Ouellet ODL

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wasserkocher Ouellet ODL